Patera Dragonfly Necklace

Patera Large Heart Pendant

Dragonfly Picture

Magic-Glos and E600 Glue

26" Package 6mm Teal Italian Mesh Ribbon

16" Vintaj Natural Brass Fine Oval Chain

1 - 7.25mm Vintaj Jump Ring

2 Vintaj Crimp Ends

Vintaj Hook and Eye Clasp

Glue your Dragonfly Heart picture securely into the Patera Heart Pendant with E600 glue. It must be glued down tightly so the Magic-Glos cannot seep under the picture. Slowly pour the Magic-Glos over the top of your picture until the desired thickness. At this point it is crucial to be patient and remove all bubbles. Bubbles may be removed using a needle, wiping the needle off before each time you pop a bubble. You may also use your finger pulling them over the side. If you are using a picture with Photo Paper  you must cover the photo paper with Packing Tape before using the Magic-Glos.`When you are ready to start the process of hardening the Magic-Glos place your Pendant outside in direct sunlight or under our UV Curing Lamp. Magic-Glos will solidify in approximately 20 minutes but only after being placed under UV rays from the direct sun or the curing lamp. After your Pendant has cured, attach the 7mm Jump Ring to the Patera Pendant. Also open and attach the middle link of your Vintaj chain to the Patera Pendant. String your Italian Mesh Ribbon through the Jump Ring and ruffle it to match the length of your Vintaj chain. Fold the ends of your ribbon between your fingers to make a narrow end that will fit inside your Vintaj Crimp Ends. Put E600 glue on this ribbon end making an encasing of the ribbon. Allow this to dry. Squeeze the crimps closed alternating sides. Open your Clasp ends and connect the Crimp Ends and your Chain to the clasp. Remember to straighten your Italian Mesh Ribbon and reruffle it each time before you wear it. We call this Freshening your Mesh Necklace. Enjoy!